|
Failure analysis of reformer tubes |
|
Failure analysis of gear of oil pump |
|
Optimization of fixture of prependicular quench-temper furnace |
|
Effect of hydrated CaO on sintering |
|
Preparation of certificate for water-cooled pipes in preheating furnaces |
|
Repaire of parts by welding |
|
Repaire of well-worn pipes of reformers |
|
Weldability of cast iron parts and determination of optimum parameters |
|
Methods for prevention of formation of unwanted graphites in grey iron cast automotive parts |
|
Methods for increase of carbon activation in CIL circuit |
|
Elimination of impurities such as As and Sb from steel |
|
An investigation on improvement of quality of sinter and increase of efficiency |
|
New technologies in iron and steel industries |
|
New technologies in iron and steel industries, Isfahan steel company, 2005-2006. |
|
Affecting parameters on HMR and reduction of HMR |
|
Effect of stabilizing temperature and cooling rate on sensitivity of 347 stainless steel welds to knife line attack |
|
Repair of flanges placed in drainage of catalysts of refrormers by elding |
|
Resistance welding and affecting parameters on cell welding |
|
Optimization of Bolts of batteries |
|
Affecting parameters on machinability of CK45 steel |
|
An investigation on recuction of FeO content in sinter |
|
A feasibility study on fabrication of HIP equipment |
|
Life extension of gear box forging dies |
|
New technologies in iron and steel industries |
|
An investigation on tearing of welds |
|
A feasibility study on production of IF steel in Mobarakeh steel Company |
|
A feasibility study on hot charging in Mobarakeh steel Company |
|
Simulation of ignition in Ghaem reactor 2 and effect of parameters, Isfahan steel Company |
|
Improvement in mechanical properties of wires in 350 plant, Isfahan steel Company |
|
Improvement in properties of rolls, Isfahan steel Company |
|
Optimization of equipments and heat treatment cycles of dies |
|
Reduction in oxidation in preheatinf furnaces, Isfahan steel company |
